| Home | About us | Contact Us |
|
|
|||||
|
|
|
 install manual K-1010
Island
hoods Instruction
manual (For: K-1010)
CONTENT 1.Notice 2.Feature 3.Installation 4.Notice of
installation 5.Safety
Warning 6.Use 7.Maintenance 8.Warranty
card
1
NOTICE 1.
Thank you for
choosing our cooker hood. Please read the instruction manual carefully before
use. 2.
The installation
work must be undertaken by a qualified and competent
fitter. 3.
The manufacturer
disclaims all liability for any damage or injury caused as a result of not
following instructions for installation contained in the following
text. The cooker hood
is used on 110/120V, 60Hz.
2
(2)FEATURE 1. The cooker hood uses high quality materials, and is
made with a streamlined
design. 2. Equipped with a
large power low noise electric motor and centrifugal leaf, it produces strong
suction, low noise, non stick grease filter and easy to
clean. 3. With the isolated low voltage circuit board
control, 12vAC input, the lights are therefore
safer. 4. Special wind tunnel construction and oil
collector design, free dirt will be absorbed in a
second.
3 (3).
Installation 1.
The ceiling must can bear at least 40kgs weight, and the
thickness of the ceiling must be ≧ 2.
According to the
hanging board, drill 12 holes in the ceiling, see pic 2, 12pcs of
ST6* 3.
Let the one side
of the extensible pipe go outside through the hole of 4.
4pcs ST4*8 big
flat screws will be used to connect the internal chimney into the hanging board,
then put one the external chimney, two hooks will be used to put up the external
chimney in order to the next installation, see pic
4. 5.
4pcs ST4*8 big
flat screws will be used to install the outlet, see pic
5. 6.
Adjust the 4 glass
screws to check whether the glass and the cooker hood body connected well and
fixed, see pic 6. 7.
Hold up the hood,
16pcs M4*10 big flat screws will be used to connect the hood body into angle
iron, see pic 7. 8.
(4) NOTICE OF
INSTALLATION 1.
Before
installation, please ensure the area is clean to avoid suction of the remaining
bits of broken wood and dust. 2.
It cannot
share the same air ventilation tube with other appliance such as gas tube,
warmer tube, and hot wind tube. 3.
The bending of
ventilation tube should be?
120?, parallel or
above the start point and should be connected to the external
wall. 4.
After
installation, make sure that the extractor is level to avoid grease collection
at one end.
(5) SAFETY WARNING ?
Never let the children operate the
machine ?
The cooker hood is for home use only, not suitable for
barbecue, Roast shop and other commercial purpose. ?
Please ask the technical person to do the
assembling. ?
The cooker hood and its filter mesh should be clean
regularly in order to keep in good working order. ?
Before cleaning, please switch the power off at the main
supply. ?
Clean the cooker hood according to the instruction manual
and keep the cooker hood from the danger of
burning. ?
If there is any fault with the appliance, please call
the service department to arrange a service engineer. （6） Speed
adjustment .See pictures 1.
Turn on the
power; the buzzer will buzz five times. The sound shows that the appliance is
powered. 2.
Push the low
button, the indicating light 1 on, the buzzer will buzz once, and the motor runs
at low speed. Push it again and the motor will
stop. 3.
Push the
middle button, the indicating light 2 on, the buzzer will buzz once, and the
motor runs at mid speed. Push it again and the motor will
stop 4.
Push the high
button, the indicating light 3 on, the buzzer will buzz once, and motor runs on
high speed. Push it again and the motor will stop 5. Push the light button; the indicating light 4 on, and the two lighting lamps will come on. Push it again and the lamps will turn off, with every push the buzzer will buzz one time.
(7)
MAINTENANCE 7.1 The cleaning of the carbon grease filter
mesh The filter mesh is made of high-density stainless steel.
Please do not use the corrosive detergent on it. Keeping this filter clean will
keep the appliance running correctly. Please strictly follow the guidelines
below. Method 1: Put the mesh into 40
Method 2: If instructed to
do so, it can be put into a dishwasher, set the temperature at around 60
degrees.
7.2 Notice of
cleaning cooker hood A.
To protect the
main body from corrosion over a long period of time, the cooker hood should be
cleaned with hot water plus non corrosive detergent every two
months. B.
Please do not
use abrasive detergent for it will damage the body. C.
Keep the motor
and other spare parts free from water, as this will cause damage to the
appliance. D.
Before
cleaning the appliance please remember to cut off
power E.
The carbon
filter shouldn?t be exposed to heat. F.
Please don?t
tear open the fixed bar around the carbon filter G.
If the plug or
cord is damaged, please replace it with special soft
cord. 8. Abnormity and
Solution
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Categories 
All credit card transactions are secured with PayPal SSL encryption.
